Chase Research IOPRINT+ Print Server Betriebsanweisung PDF herunterladen (Seite 84)

Windows NT Server (TCP/IP)

Page 84

Chapter 2 Installation and Configuration

Ip address configuration

To have the IOPRINT+ Print Server recognized as a valid device, first configure it, then follow

this procedure.

1. Add an entry for the IOPRINT+ Print Server to the hosts file:

\SYSTEM32\DRIVERS\ETC\HOSTS

The entry consists of the following line:

xxx.xxx.xxx.xxx Name

Where:

xxx.xxx.xxx.xxx is the IP Address you assigned to the IOPRINT+ Print Server.

Name is the IOPRINT+ Print Server's name. If you have not changed the name, use the

default name shown on a sticker on the base of the device. The default name is in the

form SCxxxxxx (SC followed by 6 digits).

2. Add an entry to the ARP table by entering the following commands:

arp -s IP_address 00:c0:02:xx:yy:zz

Where:

IP_address is the IP Address used in step 1.

00:c0:02:xx:yy:zz is the physical address of the IOPRINT+ Print Server, as determined

from the default name. Example:

arp -s 168.192.1.40 00:c0:02:12:34:56

3. Check the IP Address using the ping command:

ping Name

Where Name is the value used in step 1. You should receive a response. If you get a

Timeout message, the above procedure has failed.

Preparing for tcp/ip printing

To create a TCP/IP remote printer Microsoft TCP/IP printing support must be installed. The

procedure is as follows.

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 304 305

Keine Kommentare

Chase Research IOPRINT+ Print Server Betriebsanweisung Seite 84