Chase Research IOPRINT+ Print Server Betriebsanweisung PDF herunterladen (Seite 55)

Unix - TCP/IP

Page 55

Chapter 2 Installation and Configuration

LPD Printing Configuration

LPD is a built-in printing protocol for most UNIX systems, and is also supported in Windows

NT 3.5 or later.

LPD on IBM AIX 4.15

Before proceeding, ensure that the IOPRINT+ Print Server has been assigned an IP

Address. To setup your AIX system for LPD printing, perform the following steps.

1. Add the IOPRINT+ Print Server to /etc/hosts.lpd, using the name you assigned to the

IOPRINT+ Print Server.

2. Start the LPD daemon if it is not running, using the following command:

start src -s qdaemon

3. Start the system administration tool smit and select Print Spooling

4. Create the required number of queues (one for each logical printer) by selecting:

• Add a Print Queue

• Remote (Printer attached to Remote Host)

• Standard Processing

5. Use the following information:

6. Ensure that the logical printers are configured in the IOPRINT+ Print Server. Refer to

Logical Printers on page 49

7. Print using the following command:

lp -d printer_queue file_name

Where

printer_queue is one of the entries used in Name of queue to add.

file_name is the file you wish to print.

Field Entry

Name of queue to add Use a single-word queue name which indicates which

printer is attached.

Hostname for remote

server

IOPRINT+ Print Server name as used in /etc/hosts.lpd.

Name of queue on remote

server

Logical printer number (L1..L3 or L1..L8) to service this

queue.

Type of print spooler on

remote server.

Use default value (AIX Version xxx)

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 304 305

Keine Kommentare

Chase Research IOPRINT+ Print Server Betriebsanweisung Seite 55